Bose Gas Formula Sheet
This sheet specializes the Quantum Gas Formula Sheet to ideal bosons. Its central bookkeeping rule is to separate a potentially macroscopic ground mode before replacing excited-state sums by continuum integrals.
The derivations and physical interpretation remain in Bose–Einstein Statistics, Ideal Bose Gas, Bose–Einstein Condensation, Quantum Gases in Traps, and Low-Dimensional Quantum Gases.
Default Scope
Section titled “Default Scope”Unless stated otherwise:
- the particles are noninteracting bosons of mass ;
- the continuum is homogeneous and dimensional;
- ;
- the ground energy is shifted to ;
- counts internal components sharing one chemical potential and spectrum;
- is total density across those components;
- and ;
- at finite volume;
- the thermodynamic limit follows periodic finite-volume state counting.
The factor is not mechanical: separately conserved components require separate number equations and chemical potentials, while a degenerate ground manifold can change how condensate occupation is distributed.
Core Distribution and Bound
Section titled “Core Distribution and Bound”The Bose–Einstein occupation is
Positivity and convergence require
for an ordinary finite-volume grand-canonical state. With ,
The thermodynamic condensation boundary is approached as
For bosonic quasiparticles whose number is not conserved in equilibrium, the chemical potential is normally fixed to zero rather than determined by a number equation.
Exact Independent-Mode Formulas
Section titled “Exact Independent-Mode Formulas”For one-particle modes ,
Define
The one-mode probability law is geometric:
The grand partition function and grand potential are
The mean and variance of one mode are
The one-mode entropy is
These fluctuation formulas apply to independent grand-canonical modes. A fixed total particle number correlates the occupations.
Separate the Ground Mode
Section titled “Separate the Ground Mode”For , the ground-mode occupation is
Therefore
For ,
The exact number equation is
Only the excited sum should be replaced by a smooth continuum integral near condensation. Absorbing the ground mode into the density of states erases the degree of freedom that becomes macroscopic.
The ground-mode grand potential is
Even when , in the thermodynamic limit. The ideal condensate therefore changes density without adding an extensive pressure contribution.
Free-Continuum Density of States
Section titled “Free-Continuum Density of States”For the quadratic dispersion,
The thermal de Broglie wavelength is
Use
only when the excited spectrum is sufficiently dense on the relevant thermal scale.
Bose Functions
Section titled “Bose Functions”Define
The integral representation is
Useful identities are
For ,
The degeneracy factor and the Bose function are different objects. The subscripted function should never be mistaken for the number of internal components.
Normal-Phase Master Formulas
Section titled “Normal-Phase Master Formulas”Let
When the ground-mode density is negligible,
The pressure, grand potential, and internal energy are
The entropy per particle is
At fixed density, follows from the number equation. Its logarithmic derivative is
The normal-phase heat capacity at fixed and is
This formula assumes a homogeneous quadratic gas and a smooth thermodynamic limit. It should not be transplanted unchanged to a trap or lattice band.
Thermal-Cloud Saturation
Section titled “Thermal-Cloud Saturation”At fixed , the excited-state density increases with and reaches
when , provided .
For a quadratic homogeneous gas, saturation therefore requires
If , the excess density cannot enter the continuum thermal cloud. In the ideal thermodynamic limit it appears as .
Uniform Condensation Temperature
Section titled “Uniform Condensation Temperature”For ,
In three dimensions,
The condensate fraction below is
These formulas assume a homogeneous ideal gas, fixed total density, a nondegenerate spatial ground mode apart from the stated internal structure, and a thermodynamic limit.
Condensed-Phase Thermodynamics
Section titled “Condensed-Phase Thermodynamics”Below , set in the thermodynamic-limit thermal cloud. Then
The entropy and heat capacity per total particle are
For the three-dimensional gas,
At , the last coefficient is approximately . The ideal three-dimensional heat capacity is continuous at , while its derivative is nonanalytic.
Three-Dimensional Lookup
Section titled “Three-Dimensional Lookup”For a homogeneous quadratic gas:
| Quantity | Normal phase | Condensed phase |
|---|---|---|
| activity | from | |
| thermal density | ||
| condensate density | negligible in thermodynamic normal phase | |
| pressure | ||
| energy | ||
| mode variance | same mode law, with ground-mode caveat |
Useful constants are
Compressibility and Number Response
Section titled “Compressibility and Number Response”In the normal phase,
The isothermal compressibility is
For , diverges as . The uniform ideal gas becomes infinitely compressible at the condensation boundary and throughout the condensed thermodynamic-limit phase, because added density can enter the zero-energy mode without changing or pressure.
This pathological softness is removed by repulsive interactions. It is one reason the ideal condensate is not a complete model of a physical superfluid.
Ground-Mode Fluctuation Caveat
Section titled “Ground-Mode Fluctuation Caveat”In the grand-canonical ideal gas,
If , then
This order-one relative fluctuation is often called the grand-canonical fluctuation problem or “grand-canonical catastrophe.” It reflects the combination of an exactly ideal zero mode and unconstrained particle exchange. Canonical fixed- calculations correlate with the thermal cloud and do not inherit this variance unchanged.
Do not use this grand-canonical result as a universal claim about condensate fluctuations in finite traps or interacting gases.
Dilute Classical Limit
Section titled “Dilute Classical Limit”Let
Then
The pressure is
The negative correction is an exchange-statistics effect, not evidence for an attractive two-body potential.
General Dispersion and Critical Dimension
Section titled “General Dispersion and Critical Dimension”For
the low-energy density of states scales as
At , the thermal-number integrand behaves as
It is integrable at zero energy only if
For a quadratic gas, and the criterion is . A uniform ideal gas in one or two dimensions therefore has no finite-temperature thermodynamic Bose condensation transition. Finite size, confinement, altered dispersion, and interactions can produce crossovers or other kinds of order, but they do not invalidate the stated homogeneous ideal-gas result.
Harmonic-Trap Translation
Section titled “Harmonic-Trap Translation”For a three-dimensional anisotropic harmonic trap with
the semiclassical excited-state density of states is
When is large compared with the level spacings,
The ideal trap condensation scale and condensate fraction are
These are leading semiclassical ideal-trap formulas. Finite-size shifts, interactions, anisotropy beyond , and the experimental definition of the transition require the canonical Quantum Gases in Traps treatment.
Model-Boundary Translations
Section titled “Model-Boundary Translations”Lattice bosons
Section titled “Lattice bosons”Use the actual band dispersion and Brillouin-zone density of states. A flat or bounded band can change low-energy counting, and interacting Bose–Hubbard systems are not described by independent Bose occupations of the bare lattice modes.
Weak interactions
Section titled “Weak interactions”Repulsive interactions generate a finite compressibility, alter the transition temperature, and replace free-particle low-energy excitations by collective modes. Use the Gross–Pitaevskii Equation and Bogoliubov Theory only within their stated dilute weak-coupling regimes.
One-dimensional gases
Section titled “One-dimensional gases”The Lieb–Liniger and Tonks–Girardeau limits are interacting one-dimensional models. Their correlations and thermodynamics cannot be obtained by inserting an effective chemical potential into the uniform ideal Bose formulas.
Condensation versus superfluidity
Section titled “Condensation versus superfluidity”Macroscopic ground-mode occupation and superfluid response are distinct concepts. The uniform ideal Bose gas has condensation in but pathological compressibility and no interaction-generated sound mode.
Fast Consistency Checks
Section titled “Fast Consistency Checks”- for a finite conserved-particle ideal Bose gas with .
- The ground mode is separated before taking the continuum limit.
- is dimensionless.
- has pressure units.
- recovers Maxwell–Boltzmann occupation.
- is allowed only with its convergence and ground-mode qualifications.
- The uniform quadratic condensation criterion is .
- The homogeneous condensate exponent is ; the three-dimensional harmonic-trap exponent is .
- At with , the ideal gas has .
- A prediction of infinite compressibility signals the ideal-model boundary, not a robust material property.
Common Mistakes
Section titled “Common Mistakes”- Setting in a finite-volume number equation without separating the ground mode.
- Treating as a normalized probability density over energy.
- Calling every bosonic system a gas of independently occupied bare modes.
- Inserting internal degeneracy without specifying conversion among components.
- Using the homogeneous formula for a harmonic trap.
- Inferring a finite-temperature uniform ideal-gas transition in .
- Identifying ideal-gas condensation with superfluidity.
- Interpreting the negative virial correction as an attractive potential.
- Taking grand-canonical condensate fluctuations as ensemble independent.
- Applying ideal-gas compressibility or heat-capacity formulas after interactions become important.
Cross-Links
Section titled “Cross-Links”- Quantum Gas Formula Sheet
- Symbols and Conventions
- Bose–Einstein Distribution Formula Card
- Bose–Einstein Statistics
- Ideal Bose Gas
- Bose–Einstein Condensation
- Quantum Gases in Traps
- Low-Dimensional Quantum Gases
- Maxwell–Boltzmann Limit
- Weakly Interacting Bose Gas Preview
- Gross–Pitaevskii Equation
- Bogoliubov Theory
- Lieb–Liniger Model Preview
- Tonks–Girardeau Gas Preview
References
Section titled “References”- R. K. Pathria and P. D. Beale, Statistical Mechanics, 3rd ed., Elsevier (2011) — ideal Bose gases and ensemble thermodynamics.
- K. Huang, Statistical Mechanics, 2nd ed., Wiley (1987) — Bose functions, condensation, and fluctuations.
- C. J. Pethick and H. Smith, Bose–Einstein Condensation in Dilute Gases, 2nd ed., Cambridge University Press (2008) — uniform and trapped gases and interaction boundaries.
- L. Pitaevskii and S. Stringari, Bose–Einstein Condensation and Superfluidity, Oxford University Press (2016) — finite-temperature Bose gases, condensates, and collective behavior.
- L. D. Landau and E. M. Lifshitz, Statistical Physics, Part 1, 3rd ed., Butterworth–Heinemann (1980) — ideal quantum gases and thermodynamic limits.
- W. Ketterle and N. J. van Druten, “Bose–Einstein condensation of a finite number of particles trapped in one or three dimensions,” Physical Review A 54, 656 (1996) — finite trapped-gas state counting and dimensional crossover.
Exercises
Section titled “Exercises”1. Ground-mode chemical potential
Section titled “1. Ground-mode chemical potential”Starting from , solve for and find its large- behavior.
Solution
Rearranging gives
Since ,
For , use :
Thus the finite-volume chemical potential remains negative and approaches the ground energy from below.
2. Critical dimension
Section titled “2. Critical dimension”Use the low-energy density of states for to derive the criterion for saturation of the thermal cloud.
Solution
The density of states scales as
At and low energy,
The thermal-number integrand is therefore
Its integral at zero is finite if
or
For , the condition is .
3. Condensate fraction and heat capacity
Section titled “3. Condensate fraction and heat capacity”For a homogeneous quadratic gas with , derive the condensate fraction and the condensed-phase heat capacity at fixed .
Solution
Below , and
Because and ,
Therefore
The thermal energy is
so . Differentiating and eliminating with the critical-number equation gives
4. Grand-canonical ground-mode fluctuation
Section titled “4. Grand-canonical ground-mode fluctuation”Show that the relative root-mean-square ground-mode fluctuation approaches one when is macroscopic.
Solution
For a geometric mode distribution,
Hence
The result is specific to the grand-canonical ideal zero mode. A fixed total number or interactions change the fluctuation problem.
5. Leading classical pressure correction
Section titled “5. Leading classical pressure correction”Let . Derive the first Bose correction to the classical pressure.
Solution
The small- expansions are
Inverting the number series gives
Substitution into the pressure series yields
The negative sign reflects Bose exchange statistics, not an attractive interaction.
6. Harmonic-trap exponent
Section titled “6. Harmonic-trap exponent”Use the three-dimensional harmonic-trap density of states to derive the ideal condensate fraction exponent.
Solution
At ,
At the trap condensation temperature,
Taking the ratio gives
Therefore
The exponent comes from the harmonic-trap density of states and differs from the homogeneous three-dimensional exponent .